
On November 13, a network issue prompted the FAA to impose a nationwide ground stop. Flights resumed around 8:15 p.m. ET, but the recovery took much longer. The FAA reported that operators canceled about 12,000 flights.
What Happened
According to the FAA, legacy equipment became unstable when its network was flooded with connection attempts, about 1,000 every four to five seconds. The initial investigation identified two sites: a radar site in Amarillo, Texas, and a radio site in El Dorado, Arkansas. The network service provider had been working at the El Dorado site, including deploying a new router. After the two locations were blocked, the network stabilized. The FAA reports no indication of a cyberattack, and the investigation is ongoing.
The details may change, but the pattern will feel familiar to any network team: a routine change, an unexpected surge in traffic, and instability that spreads. The FAA reported issues at 17 of its 22 en route control centers. Reports indicate that it took about 45 minutes just to pinpoint where the change occurred. Ouch.
Why Resilience Matters
Even routine changes can pose risks at an enterprise scale. One router deployment shouldn’t be able to take down a national system, but without strong validation and containment, it can.
Lack of visibility can turn minutes into hours. Unless you can quickly identify what changed and where, you can’t recover quickly.
Technical debt can make the impact even greater. The FAA identified legacy TDM infrastructure as the cause of the instability.
Manual changes pose a significant risk. Gartner’s Market Guide for Network Automation Platforms reports that 67% of enterprise networking activities are performed manually. The result is poor incident and change performance.
How Kilter by BackBox Helps
The good news is that Kilter is built around core disciplines, including:
- Automated backup and restore. Known-good configurations are saved regularly, making rollbacks quick and eliminating the need for manual triage.
- Automated change and upgrade workflows. Updates like OS upgrades use consistent, repeatable automation rather than one-off CLI sessions, helping reduce human error.
- Pre- and post-change validation. Automations can capture device state before a change and verify it afterward, catching problems before they spread.
- Visibility into your estate. An up-to-date view of devices, versions, and end-of-life status helps you identify aging, unsupported assets before they become single points of failure.
- Compliance and configuration checks. Automated checks against your standards help keep devices aligned with best practices.
- Multi-vendor coverage. Real-world networks are heterogeneous, and the same process discipline applies across vendors.
The Key Takeaway
Resilience isn’t something we can take for granted. It requires thoughtful engineering, testing, and automation. This incident is a helpful opportunity to ask: Do we know what’s on our network? Can we validate every change? Can we roll back in minutes?
Explore how a platform like Kilter brings automation, device lifecycle management, compliance, and other resilience capabilities together in one place, helping organizations reduce operational risk. Schedule a 30-minute demo.
Written by
Stephanie Stouck
